Jetta V6-2.8L (BDF) (2002)
-
The respective fuses of Motronic Engine Control Module (ECM) - J220- must be OK.
-
Fuel Pump (FP) Relay -J17- must be OK, check.
-
Generator (GEN) must be OK, checking.
-
Battery voltage must be at least 11.5 volts.
-
All electrical consumers like, for example, lights and rear window heating must be switched off.
-
Parking brake must be engaged or else daylight driving lights will be switched on.
-
For vehicles with automatic transmission, selector lever must be in position -P- or -N-.
-
If vehicle is equipped with an A/C system, it must be switched off.
-
Ground (GND) connections between engine and chassis must be OK.
Test sequence
-
Connect test box to control module wiring harness, connect test box for wiring test.
See: Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/With Generic Scan Tool/Test Box, Connecting For
Wiring Test
Checking voltage supply terminal 30
-
Measure voltage supply between sockets 1 + 62 and 2 + 62 of test box.
Specified value: at least 11.5 V
If specified value is not obtained:
-
Check wire connections to relay carrier and Ground (GND) connection of Engine Control Module (ECM) according to wiring diagram:
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
See: Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code.
See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
Checking voltage supply terminal 15
-
Measure voltage supply between sockets 1 + 3 and 2 + 3 of test box.
-
Switch ignition on.
-
Specified value: at least 11.5 V
If specified value is not obtained:
-
Check wire connections to relay carrier and Ground (GND) connection of Engine Control Module (ECM) according to wiring diagram.
-
Erase DTC memory of Engine Control Module (ECM), Diagnostic mode 4: Reset/erase diagnostic data.
See: Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code.
See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes