Jetta V6-2.8L (BDF) (2002)
-
Check wiring for open circuit between test box and connector referring to wiring diagram.
Contact 1 and socket 72
Contact 2 and socket 73
Contact 3 and socket 36
Contact 4 and socket 35
Contact 5 and socket 33
Contact 6 and socket 34
Wire resistance: max. 1.5 Ohms
-
Additionally check wiring for short to battery positive or Ground.
-
Additionally check wires for short to one another.
If no wiring malfunction is detected:
-
Replace TP sensor / Sender for accelerator pedal position.
-
Check Diagnostic Trouble Code (DTC) memory:
Refer to Powertrain Management
-
Read readiness code
-
Generate readiness code again if DTC memory has been erased or engine control module disconnected from permanent positive supply:
Refer to Powertrain Management
Models with an automatic transmission
-
Adapt (match) transmission control module:
Refer to Powertrain Management; Basic setting