Jetta V6-2.8L (BDF) (2002)
If the DTC memory has been erased or the Engine Control Module (ECM) was disconnected from battery positive, the readiness code must be generated
again.
See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
If no wiring malfunction is detected and no voltage was present between terminals 1 and 3:
-
Replace Engine Control Module (ECM).
-
Check DTC memory, repair malfunctions if necessary and then erase DTC memory.
See: Computers and Control Systems/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/Reading Diagnostic Trouble Codes
-
Erase learned values and adapt Engine Control Module (ECM) again.
-
Read readiness code. If the DTC memory has been erased or the Engine Control Module (ECM) was disconnected from battery positive, the
readiness code must be generated again.
See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
Check sequence for Camshaft Position (CMP) Sensor 2 -G163-
-
Pull 3-pin connector -2- off Camshaft Position (CMP) Sensor 2 -G163-.
NOTE: Mark connector and component before pulling connector off.
-
Connect multimeter to measure voltage at terminals 1 (positive) and 3 (ground) of Camshaft Position (CMP) Sensor connector using adapter
cables from V.A.G 1594.
-
Switch on ignition.
Specification: at least 4.5 V
-
Switch off ignition.
If no voltage is present:
-
Remove wiper arms and cowl panel: