Jetta V6-2.8L (BDF) (2002)
-
Pull selector lever cable -1- upward off lever/selector shaft -4-.
-
Remove circlip -3- at support bracket.
-
Raise vehicle.
-
Separate exhaust system by loosening clamping sleeve.
-
Remove tunnel heat shield front and rear.
-
Remove cover from selector lever housing.
-
Pry selector lever cable -3- off selector lever -2- with a screwdriver.
-
Pull circlip -1- for securing selector lever cable to selector lever housing out downward.
-
Pull selector cable carefully out of selector lever housing.
-
Remove selector mechanism rear securing bolts.
-
Support selector mechanism from below.
-
Remove solenoid securing bolts (Qty. 2).
-
With selector lever in position "1" remove solenoid with locking pin and spring from selector lever housing. Move selector lever back and forth
slightly if necessary.
-
Loosen nut for selector lever mounting pin. Only counter-hold on mounting pin hex (mounting pin must not be turned).
-
Carefully drive mounting pin out with drift.
-
Remove selector.
Installing
Installation is performed in the reverse order of removal.
-
Adjust selector lever cable.
-
Adjust locking cable.
-
Check operation of ignition key withdrawal lock.
-
Check selector mechanism.
Selector Mechanism Disassembling and Assembling