Jetta GLS L4-1.8L Turbo (AWP) (2002)
If replacing clamps only, see "Window clamp, installing on track".
^
Remove regulator assembly (see "Regulator, removing from carrier assembly").
^
Single cable remains in installed position.
Regulator, removing from carrier assembly
On opposite side of carrier:
^
Using a small flat blade screw driver to press lock tabs on three mounting pins (arrows) inward while applying downward pressure to regulator
with finger (as shown).
Tip: Note placement of foam isolator washers at each mounting pin location (may come off with motor).
Tip: New washers are included in kit and must be installed between window regulator and motor on final assembly of motor to regulator.
^
Clean any grease and dirt from tracks and around regulator insertion hole (arrow).
^
Carrier assembly is now ready to install new cables.
Regulator assembly, preparing for installation