Jetta GLS L4-1.8L Turbo (AWP) (2002)
Brake Pedal Assy: Service and Repair
Assembly Overview
Brake pedal, assembly overview
WARNING! The brake pedal travel must not be restricted by additional floor mats.
Note: Grease all mountings before installing with grease, Part No. G 000 602.
1
Mounting bracket
2
self-locking nut
^
28 Nm (21 ft. lbs.)
^
Always replace
3
Brake light switch
^
Before installing brake light switch, connect brake pedal to brake booster push rod.
^
Before installing, pull plunger out completely
Installing:
^
Push brake pedal down as far as possible by hand.
^
Guide switch through mounting hole (only fits in one position) and secure by turning switch 90° clockwise
^
Release brake pedal.
^
Connect wiring connector.
^
Check function of brake lights.
^
Pull out brake light switch plunger to full extension.
^
Keep brake pedal in up position (IMPORTANT! hold pedal up if necessary while installing switch).