Jetta GLS L4-1.8L Turbo (AWP) (2002)
Continuation for all engines
-
Press -> key.
-
Press keys 0 and 6 for "End output" function and confirm input with Q key.
-
Switch ignition off.
If the specification is not obtained:
-
Remove shelf on driver's side:
-
Pull connector off brake light/brake pedal switch
-
Connect multimeter to measure resistance between contacts 1 and 4.
Specification: infinity Ohm (no continuity)
-
Depress brake pedal.
Specification: approx. 0 Ohm
-
Connect multimeter to measure resistance between contacts 2 and 3.
Specification: approx. 0 Ohm
-
Depress brake pedal.
Specification: infinity Ohm (no continuity)
If the specifications are not attained:
-
Replace brake light/brake pedal switch.
-
Check DTC Memory, if necessary, repair any malfunctions and then Erase DTC Memory, Checking and Erasing DTC Memory. Refer to
"Displaying and Reading Trouble Codes/With Manufacture Scan Tool/Check DTC Memory (Function 02)" See: Powertrain
Management/Computers and Control Systems/Testing and Inspection
-
Read readiness code. If DTC memory has been erased or engine control module was disconnected from permanent positive, readiness code must
be generated again: Refer to "Monitors, Trips and/or Drive Cycle/ Reading Readiness Code" See: Powertrain Management/Computers and Control
Systems/Testing and Inspection
Engine code AWW, Refer to "Monitors, Trips and/or Drive Cycle/Generating Readiness Code" See: Powertrain Management/Computers and
Control Systems/Testing and Inspection
Engine code AWP, Refer to "Monitors, Trips and/or Drive Cycle/Generating Readiness Code" See: Powertrain Management/Computers and
Control Systems/Tools and Equipment
If the specifications are obtained: