Jetta GLS L4-1.8L Turbo (AWP) (2002)
Information Bus: Scan Tool Testing and Procedures
End Output (Function 06)
End Output (function 06)
-
Press buttons -0- and -6- to select "End Output" function 06.
Indicated on display:
Rapid data transfer
Q
06 - End Output
-
Press -Q- button to confirm input.
Indicated on display:
Rapid data transfer
HELP
Enter address word XX
-
Switch off ignition.
-
Disconnect VAG 1551 from Data Link Connector (DLC).
Reading
Read Measuring Value Block (function 08)
Use this function to observe status of communication between control modules via the CAN Bus..
The measuring value block is divided into 2 display groups, each containing 4 display fields.
-
Connect VAG 1551, select operating mode 1 "Rapid data transfer", switch on ignition and enter address word 17 "instrument cluster".
-
Press -Q- button to confirm input.
-
Press -> button until "Select function" is displayed.
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press buttons -0- and -8- to select "Read Measuring Value Block" function 08.
Indicated on display:
Rapid data transfer Q
08 - Read Measuring Value Block
-
Press -Q- button to confirm input.
Indicated on display:
Read Measuring Value Block HELP
Enter display group number XXX
-
Using the Scan Tool (ST) button pad, enter the required display group number (following example shows display group 001).
-
Press -Q- button to confirm input.
Indicated on display: (1...4 = Display fields)
Read Measuring Value Block 1
->
1
2
3
4