Jetta GLS L4-1.8L Turbo (AWP) (2002)
-
Check the voltage supply for the Mass Air Flow (MAF) sensor.
If the specification is not obtained:
-
Check signal and Ground (GND) wires for the Mass Air Flow (MAF) sensor.
If the specification is obtained:
-
Press the -> key.
-
Press keys 0 and 6 for the "End output" function and confirm input with the Q key.
-
Switch ignition off.
Checking voltage supply for Mass Air Flow (MAF) sensor
-
Pull 5 pin connector -1- off Mass Air Flow (MAF) sensor -2-.
-
Connect multimeter to measure voltage on connector contact 2 and engine Ground (GND).
-
Start engine and run at idling speed.
Specification: 11 to 15 V
If no voltage is present:
-
Switch ignition off.
-
Check wiring from contact 2 to fuel pump relay (J17) according to wiring diagram.
If the voltage supply and wiring is OK:
-
Switch ignition on.
-
Connect multimeter to measure voltage on connector contact 4 and engine Ground (GND):
Specification: 4.5 to 5.5 V
If no voltage is present:
-
Switch ignition off.
-
Check signal and Ground (GND) wires.
Testing signal and Ground (GND) wires for Mass Air Flow (MAF) sensor