Jetta GLS L4-1.8L Turbo (AWP) (2002)
-
The fuses must be OK.
-
The battery voltage must be at least 11.5 V.
Test sequence
-
Connect VAG 1551 scan tool ((V.A.G 1552) and with ignition switched on select engine electronics control module with the "Address word" 01:
Indicated on display:
Rapid data transfer
HELP
Select function XX
-
Press keys 0 and 8 for the function "Read measured value block" and confirm entry with Q key.
Indicated on display:
Read measured value block
Input display group number XXX
-
Press keys 0, 6 and 2 for the "Display group number 62" and confirm entry with Q key.
Indicated on display: (1 to 4 = Display zones)
Read measured value block 62
->
1
2
3
4
-
Check specification of sender 1 (G79) at idling stop in display zone 3.
Specification: 6 to 96 %
-
Check specification of sender 2 (G185) at idling stop in display zone 4.
Specification: 3 to 48 %
NOTE: The engine control module calculates the voltage values of the angle sender in percent relative to 5 Volt and displays these as a percentage
figure (5 Volt supply voltage equates to 100%).
-
Operate the accelerator pedal slowly until fully depressed and observe the angle sender figures in display zones 3 and 4:
The percent figures in display zone 3 must rise evenly. The tolerance range of 6 to 96 % is not covered completely.
The percent figures in display zone 4 must rise evenly. The tolerance range of 3 to 48 % is not covered completely.
NOTE: The figure displayed in display zone 3 must always be approximately double that displayed in display zone 4.
-
Press the -> key.
-
Press keys 0 and 6 for the function "End output" and confirm entry with the Q key.
-
Switch off ignition.
If the display does not indicate as described:
-
Check accelerator pedal position sender voltage supply and wiring connections.