Jetta GLS L4-1.8L Turbo (AWP) (2002)
-
Remove bearing bracket bolts -1- on both sides of rear axle, and lower rear axle.
Installing
-
Bleed brakes.
Grease bonded rubber bushings
-
Grease bonded rubber bushings with assembly paste before installing rear axle.
-
Install in reverse sequence
-
Check steering wheel position during test drive.
-
Check wheel alignment if steering wheel is not in straight ahead position .
Tightening torque:
Shock absorber to body 75 Nm (55 ft. lbs.)
Use new bolts!
Bearing bracket to rear axle 80 Nm (59 ft. lbs.)
Use new nuts and bolts!