Jetta GLS L4-1.8L Turbo (AWP) (2002)
/Page-1309004.png)
^
Loosen clutch housing/transmission housing securing bolts diagonally until output shaft moves freely in transmission housing.
^
Read play on gauge and note reading (Example: 0.27 mm)
Note: If dial gauge indicates no value when clutch housing/transmission housing securing bolts are loosened, install shim 1.95 mm (Part No. 084 409
383 AS) or, if necessary, shim 2.20 mm (Part No. 084 409 383 BD).
Determining thickness of shim
The specified bearing pretension will be attained by subtracting the measured value (0.27 mm) from the inserted shim (1.70 mm) and adding a
constant for pressing (0.20 mm).
Example:
^
Determine thickness of shim from table 35-82.
^
Remove transmission housing and pull tapered roller bearing outer race out of housing.
A - Counter support, e. g. Kukko 22/2
B - Internal puller 46 to 58 mm, e.g. Kukko 21/7
^
Remove inserted shim (1.70 mm thick) from clutch housing.
Shim table
