Jetta GLS L4-1.8L Turbo (AWP) (2002)
22 - Base plate
^
Open tabs to remove
^
Replace
23 - Lock washer
24 - Gate selector cable
25 - Gear selector cable
26 - Hex nut, 25 Nm
27 - Bushing
^
Only installs in one position
28 - Lock washer
Fig. 1 Removing and installing circlip
^
Pull shift lever in arrow direction -A- and at same time push down spacer bushing onto stop with a screwdriver in arrow direction -B-.
Note: Do not tilt spacer bushing when pushing down. Carefully release pressure at groove in gear lever for circlip.
Carefully release pressure at groove in gear lever for circlip.
Fig. 2 Installing spring
^
Insert spring so that spring extension -A- lies above pin (arrow).
^
Pull spring extension -B- down so that it reaches below pin (arrow).