Jetta GLS Wagon L4-2.0L (AZG) (2002)
-
Connect multimeter using aux. cables from VAG 1594 to measure voltage between contact 1 and Ground. Then switch ignition on.
Specification: At least 11.5 V
If the specification is not attained:
-
Check wiring between 2-pin connector contact 1 and fuse holder using wiring diagram.
If the specification is obtained:
-
Remove wiper arms and cowl panel
-
Connect test box VAG 1598/31 to control module wiring harness. The engine control module remains disconnected.
-
Check wiring for open circuit between test box and 2-pin connector using wiring diagram.
Contact 2+socket 39
Wire resistance: Max. 1.5 Ohms
-
Additionally check wires for short to one another.
-
Additionally check the wiring for short to battery positive or Ground.
If no fault is detected in the pipes:
-
Replace engine control module.