Jetta GLX V6-2.8L (AFP) (2002)
Constant Velocity Joint: Service and Repair
Axle Shafts, Removing and Installing
Special tools and equipment
-
3283 Press tool
-
VAG 1756 Angle wrench
-
VW 408A Press tool
-
VW 402 Press plate
-
VW401 Press plate
-
VW 522 Support sleeve
-
40-204A Tensioner
Removing
Ensure wheel bearings are not loaded with 12-point nuts loose.
If bearings are loaded by vehicles weight and 12-point nuts are loose wheel bearings will be stressed and their life expectancy reduced.
If a vehicle is moved after removing axle shaft, first install outer joint and tighten to 50 Nm (37 ft. lbs.).
-
Lift vehicle to relieve load on front axle.
-
Loosen 12-point nut.
-
Disconnect axle shaft from transmission drive flange.
-
-Mark bolt installation position.