Jetta GLX V6-2.8L (AFP) (2002)
/Page-1219002.png)
VW309 Holding plate
2050 Press tool
VAG1331 Torque wrench
1 - Kukko 21/7 Internal puller
4 - Kukko 22/2 Counter support
It is necessary to readjust the output shaft when the following components are replaced:
^
Transmission housing
^
Clutch housing
^
Output shaft for 1st-4th gear
^
Or
^
Tapered roller bearing
Requirements
^
Sealing surfaces of clutch and transmission housings must be free of sealant.
^
When taking measurements, install only the shaft to be measured.
