Jetta GLX V6-2.8L (AFP) (2002)
-
Remove gear lever housing front securing nuts (arrows).
-
Separate front exhaust pipe -A-.
-
Remove cross support -B- below exhaust system.
-
Loosen heat shield -C- in forward area.
-
Remove heat shield -D-.
-
Unbolt selector housing from body.
-
Swing gear shift housing down and remove with selector cables.
Installing
Installation is carried out in the reverse sequence. Also, note the following:
Selector mechanism up to 12.00
To reuse cables, cable locking mechanisms must be replaced.