Jetta Sedan L4-1.8L Turbo (AWP) (2003)
Steering Angle Sensor: Service and Repair
Electronic Stability Program (Esp)
Electronic Stability Program (ESP)
Following steps are valid only for vehicles with Electronic Stability Program (ESP).
Vehicles with ESP are additionally equipped with a Steering angle sensor -G85-. sensor is installed in conjunction with coil connector and slip ring in a
housing.
Removing
-
Front wheels and steering wheel must be in straight-ahead position.
NOTE: Replacement slip ring is secured as a new part in center position with cable tie
Position steering wheels in central position; A yellow spot must be visible in hole - 1 -. marking - arrow - must align.
-
Disconnect steering angle sensor connection.
-
Lift hooks - arrows - carefully and remove steering angle sensor.
Installing
-
Install in reverse order of removal.
For vehicles with ESP observe following:
When installing, ensure steering angle sensor is correctly seated and is free of stress.
-
Front wheels and steering wheel must be in straight ahead position.
-
Remove transportation protection (cable tie) on markings before installing a new steering angle sensor.
-
Install steering angle sensor, until lugs engage.
-
Position steering wheels in central position; A yellow spot must be visible in hole - 1 -. marking - arrow - must align.
-
A zero compensation must then be performed.