Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
-
Press piston into brake caliper housing as far as possible by hand.
-
Press piston into brake caliper housing using piston resetting tool.
Note: The protective seal outer sealing lip will then locate in piston groove.
Rear Brake Caliper, Servicing
Rear brake caliper, servicing
Note:
^
When repairing install all parts supplied in repair kit.
^
New brake calipers are filled with brake fluid and pre-bled.
^
Apply thin coat of assembly lubricant G 052 150 A2 to brake cylinders, pistons and seals.
^
When carrying out repairs it is essential to pre-bleed the brake calipers (without brake pads) before installing in the vehicle.
1- Self-locking hex bolt, 35 Nm (26 ft. lb)
^
Always replace
^
When loosening and tightening counter-hold on guide pin
2- Bleeder valve, 11 Nm (8.1 ft. lb)