Jetta Sedan L4-1.9L DSL Turbo (BEW) (2005)
/Page-2463002.png)
person when tightening
9 - Hex socket head bolt, 8 Nm
10 - Speed sensor
11 - Stub axle
^
Straightening operations are not allowed!
^
Recutting thread is not allowed!
12 - Stone protection plate
13 - Phillips-head screw, 4 Nm
14 - Brake disc
15 - Dust cap
^
Always replace
^
Pressing out and driving in go to Wheel bearing/wheel hub on vehicles with disc brakes, removing and installing A perfect seal is only
achieved using a new dust cap.
16 - Self-locking 12-point nut, 175 Nm
^
Always replace
17 - Wheel hub with wheel bearing
^
Always replace The wheel bearing and wheel hub are installed together in a housing. This wheel bearing/hub unit is maintenance and
adjustment free. Adjusting and servicing is not possible!
18 - Hex bolt, 60 Nm
^
Always replace
19 - Shield plate
20 - Retainer for parking brake cable
21 - Parking brake cable
22 - Hex bolt, 75 Nm
^
Always replace
^
For removal of rear axle, do not loosen if possible
If weld nut threads are damaged, threads can be repaired using Heli-Coil thread inserts.
Servicing thread in side rail go to Threads in longitudinal member servicing
23 - Self-locking hex nut, 80 Nm
^
Always replace
^
When tightening nut, the axle beam must be in the horizontal position (unladen vehicle state)
24 - Hex bolt, 80 Nm
^
Always replace
25 - Rear axle bearing bracket
^
Check and if necessary adjust rear axle total track after installation
^
If possible do not loosen when removing the rear axle
26 - Hydraulic bonded rubber bushing
Distinguish between bonded rubber bushing. The hydraulic bonded rubber bushing has a bulge - arrow to the exterior of vehicle.
Bushing must be replaced if leaking
^
Removing and installing go to Hydraulic bonded rubber bushing, removing and installing
27 - Bonded rubber bushing
^
Removing and installing go to Bonded rubber bushing, removing and installing
28 - Parking brake cable clip
29 - Bolt, 20 Nm plus an additional 1/8 turn 45°
^
Always replace
30 - Vibration damper
^
Always replace
