Jetta Sedan L5-2.5L (BGP) (2005)
‹› Must always be replaced together on both sides of axle.
‹› Remove brake caliper and brake carrier before removing.
3
Bolt, 4 Nm
4
Brake pads
‹› Thickness: 14 mm without backing plate.
‹› With wear indicator.
‹› When wear limit is reached (limit: approximately 4 mm), the warning lamp lights up in the instrument cluster.
‹› Wear limit: 2 mm without backing plate.
‹› Checking thickness.
‹› Must always be replaced together on both sides of axle.
‹› Removing and installing, refer to --> [ Brake Pads ] See: Brake Pad/Service and Repair.
5
Retaining spring
‹› Insert in both holes of the brake caliper.
6
Brake carrier
‹› Bolted to the wheel bearing housing.
7
Brake caliper
‹› Do not remove brake line when replacing brake pads.
‹› Removing and installing, refer to --> [ Brake Caliper ] See: Brake Caliper.
‹› Assembly overview, refer to --> [ Front Bake Caliper Assembly Overview ] See: .
8
Guide pins, 30 Nm
9
Cap
‹› Remove
10
Brake line with ring connection and banjo fitting, 35 Nm
11
Guide pins, 30 Nm
12
Cap
‹› Remove
13
Bolt
14
Bracket
15
Bolt, ribbed, 190 Nm
‹› Clean if reusing.
16
Wheel bearing housing
‹› With bolted brake carrier.
17
Wheel speed sensor