Jetta Sedan L5-2.5L (BGP) (2005)
Cylinder head gasket must not be kinked. A kinked cylinder head gasket must be replaced.
-
Slightly bend the ends of cylinder head gasket - A - downward - arrows - only as far until upper sealing surface of cylinder head gasket and of
cylinder head can be cleaned.
-
Clean sealing surfaces of cylinder head and cylinder head gasket at top and bottom, they must be free of oil and grease.
-
Replace sealing rings - 1 - and - 2 -.
-
Cut tube nozzle at front marking (dia. approx. 1 mm).
CAUTION!
Cylinder head gasket must not be kinked. A kinked cylinder head gasket must be replaced.
-
Coat sealing surfaces of cylinder head gasket - A - at top and bottom thinly with sealant, to do so, slightly bend cylinder head gasket downward
again.