Jetta Sedan L5-2.5L (BGP) (2005)
/Page-3739009.png)
-
Push aside the side trim panel.
-
Disconnect connector - 1 -.
-
Remove the nuts - 2 - at taillamp assembly in side panel.
-
Remove taillamp assembly.
Installing
Install in reverse order of removal, noting the following:
-
Tighten the nuts - 2 - to specified tightening torque. Refer to --> [ Fastener Tightening Specifications ] See: Specifications.
‹› Taillamp assembly harness connector must engage "audibly" in side panel when connecting.
-
Check the gap dimension to the body after installing the taillamp assembly.
