volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Heated Oxygen Sensor (HO2S) G39 and Oxygen Sensor Control Before Catalytic Converter, Checking|Page 5912 > < Heated Oxygen Sensor (HO2S) G39 and Oxygen Sensor Control Before Catalytic Converter, Checking|Page 5910
Page 31
background image

Specified value: 0.0 to 30.0 ohms max. (at approx. 20° C)

If the specification was not obtained:

-

Replace the Oxygen Sensor (O2S (in Center Three Way Catalytic Converter (TWC), Bank 1 (G465). 

If the specification was obtained:

Checking voltage supply

-

Crank the engine.

-

Using a multimeter, check the Oxygen Sensor (O2S (in Center Three Way Catalytic Converter (TWC), Bank 1 (G465) electrical harness connector
terminal 1 to Ground (GND) for voltage.

Specified value: Battery voltage.

-

Switch the ignition off.

If the specification was not obtained:

-

Check the Oxygen Sensor (O2S (in Center Three Way Catalytic Converter (TWC), Bank 1 (G465) electrical harness connector terminal 1 to the
Fuel Pump (FP) Relay (J17) socket 2/87 for an open circuit or short circuit to each other, Battery (+), and Ground (GND).

Heated Oxygen Sensor (HO2S) G39 and Oxygen Sensor Control Before Catalytic Converter, Checking|Page 5912 > < Heated Oxygen Sensor (HO2S) G39 and Oxygen Sensor Control Before Catalytic Converter, Checking|Page 5910