Jetta Sedan L5-2.5L (BGP) (2005)
Specified value: about 5.0 V
-
Switch the ignition off.
If the specification was not obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the Adapter Cable (121-pin) (VAG1598/31)24 Removal and Installation.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J220). Refer to --> [ Engine Control Module, Replacing ] .
-
Using a Multimeter, Check the Camshaft Position (CMP) Sensor (G40) electrical harness connector to the Motronic Engine Control Module
(ECM) (J220) electrical harness connector T121 for resistance.
Specified value: 1.5 ohms Max.
If the specified value was not obtained: