Jetta Sedan L5-2.5L (BGP) (2005)
Engine code BGP
Engine code BGQ
Specified value: 1.5 ohms Max.
If the specification was not obtained:
-
Check the wiring for an open circuit, short circuit to each other, Battery (+), and Ground (GND).
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring:
-
Erase the DTC memory. Refer to --> [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 04 - Erase DTC Memory.
-
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. Refer to --> [ Readiness Code ] See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness
Codes/Readiness Code.
-
End of diagnosis.
If the DTC does return and no malfunction is detected in the wiring and the voltage supply was OK:
-
Replace the Motronic Engine Control Module (ECM) (J220). Refer to --> [ Engine Control Module, Replacing ] .
-
Assembly is performed in the reverse of the removal.
Final procedures