volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Heated Oxygen Sensor (HO2S) G39 and Oxygen Sensor Control Before Catalytic Converter, Checking|Page 5041 > < Diagram Information and Instructions|Page 5038
Page 1
background image

Oxygen Sensor: Testing and Inspection
Heated Oxygen Sensor (HO2S) G39 and Oxygen Sensor Control Before Catalytic Converter,
Checking

Heated Oxygen Sensor (HO2S) G39 And Oxygen Sensor Control Before Catalytic Converter, Checking

NOTE:  When servicing terminals in harness connector of Heated Oxygen Sensor (HO2S) G39, use only gold-plated terminals.

Special tools, testers and auxiliary items required

-

Hand multimeter V.A.G 1526 or Multimeter V.A.G 1715

-

Connector test set V.A.G 1594

-

Wiring diagram

Test conditions

-

The respective fuse of Heated Oxygen Sensor (HO2S) G39 must be OK.

-

Battery voltage must be at least 11.5 Volts.

-

All electrical consumers such as, lights and rear window defroster must be switched off.

-

The parking brake must be applied, otherwise daytime running lights are switched on.

-

If vehicle is equipped with an A/C system, it must be switched off.

-

The ground (GND) connections between engine and body must be OK.

-

Exhaust system must be properly sealed between catalytic converter and cylinder head.

-

Coolant temperature must be at least 80 degrees C.  See: Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/With Generic Scan Tool/Diagnostic Mode 1: Check Measured Values

-

The Oxygen Sensor (O2S) Heater Z19 before catalytic converter must be OK, checking.  See: Computers and Control Systems/Testing and
Inspection/Component Tests and General Diagnostics/Oxygen Sensor (O2S) Heater Z19 For Heated Oxygen Sensor (HO2S) G39 Before Catalytic
Converter, Checking

Function test

-

Connect the Vehicle Diagnostic and Service Information System VAS 5052.  See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/Vehicle Diagnostic and Service Information System VAS
5052, Connecting

-

Start engine and run at idle speed.

-

Under address word 33, select "Diagnostic mode 5: Read Lambda test results".

-

Select the oxygen sensor test results for the Heated Oxygen Sensor (HO2S) G39 (sensor 1) and check if the specified values are attained.  See:
Computers and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 5: Check
Lambda Test Results

-

End diagnosis and switch ignition off.

If specifications are not obtained:

-

Test oxygen sensor wires.

-

Connect test box to Motronic Engine Control Module (ECM) J220 wiring harness.  See: Computers and Control Systems/Testing and
Inspection/Reading and Clearing Diagnostic Trouble Codes/Scan Tool Connecting/Test Box, Connecting For Wiring Test

Heated Oxygen Sensor (HO2S) G39 and Oxygen Sensor Control Before Catalytic Converter, Checking|Page 5041 > < Diagram Information and Instructions|Page 5038