Jetta Sedan L5-2.5L (BGP) (2005)
/Page-2077018.png)
CAUTION:
-
Risk of injury. Observe warning notes and safety precautions.
-
Batteries that have a colorless or light yellow visual indicator must not be tested or charged. Jump starting must not be used.
-
There is a risk of explosion during testing, charging or jump starting.
-
These batteries must be replaced.
General Information:
The support mode provides the vehicle electrical system with voltage when the battery is removed or disconnected.
More information can be found in the VAS 5903 Instruction Manual.
The support mode comes on under the following situations:
-
Support mode for the vehicle electrical system when the battery is not installed
-
Maintaining the voltage when changing the battery
-
Testing the accessories without the battery
-
Turn off the ignition and all electrical consumers.
CAUTION:
-
The polarity protection of the charger clamps is not active in the operation mode "charging severely batteries/Support mode"
Connect the charger clamps to the battery terminals correctly according to polarity
-
It can result in sparks due to short circuit.
-
This constitutes an explosion risk.
-
Make sure the charge clamps are attached correctly.
-
Do not touch START / STOP if the charge clamps are connected incorrectly The charger can be damaged.
-
Remove the battery.
-
Plug in the electrical system connector of the charger. The last selected operation mode is shown on the display.
CAUTION: When the battery is removed, always make sure the positive clamp of the charging clamps does not come in contact with the
body ground. Likewise, do not let the battery terminal clamps come in contact with each other.
-
Connect the red charge cable "+" to the vehicle positive terminal.
-
Connect the black charge cable "+" to the vehicle negative terminal.
-
Press the START / STOP for approximately 5 seconds. The menu selection "Charging severely discharged batteries/Support mode" is activated.
-
Press corresponding button "Up" arrowup or "Down" downarrow, to set respective battery voltage (6 V, 12 V or 24 V).
NOTE: If no button is touched within 5 seconds, the charger will return to the main menu (operation mode selection).
-
Confirm the selected battery voltage by pressing START / STOP.
Then the inquiry about the correct polarity of the charger clamps is made.
-
Verify that the charger clamps are connected to the correct polarity.
-
Confirm that the charger clamps are connected to the correct polarity by pressing START / STOP.
The battery charger starts the support mode.
Ending the battery support:
-
Press START / STOP.
-
Remove the black charging clamp "-" of the charger from the negative battery terminal of the vehicle.
-
Remove the red charging clamp "+" of the charger from the positive battery terminal of the vehicle.
-
Pull out the electrical system connector of the charger.
Maintenance Charging With Battery Charger
Maintenance Charging With Battery Charger
CAUTION:
-
Risk of injury. Observe warning notes and safety precautions.
-
Batteries that have a colorless or light yellow visual indicator must not be tested or charged. Jump starting must not be used
-
There is a risk of explosion during testing, charging or jump starting.
-
These batteries must be replaced.
NOTE:
