Jetta Sedan L5-2.5L (BGP) (2005)
-
Coat bushing - arrow 1 - and splines of steering pinion - arrow 2 - with G 052 192 A1.
While doing this, no grease must enter the sensor or its vicinity!
CAUTION: Do not use other grease under any circumstances.
The new steering pinion with Steering Torque Sensor G269 has an anti-twist element -arrow -. This may only be removed after locking to sensor wire.
Only remove new steering pinion from packaging when it has been assembled.
Prevent contact with electrical components!
-
Observe general repair notes.
-
Insert steering pinion into steering gear housing.
-
Rotate steering pinion until spiral spring with sensor wire - arrow - can be locked. While doing this, the marking applied during removal must align
with steering gear housing.
-
Install sensor wire.
Note: