volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Transmission Control Module Can-Bus Terminal Resistance, Checking|Page 8533 > < Transmission Control Module Can-Bus Terminal Resistance, Checking|Page 8531
Page 1
background image

Control Module: Service and Repair

Transmission Control Module, Replacing

‹› To achieve optimal anti-theft protection for the vehicle, an anti-theft immobilizer was installed. The anti-theft immobilizer is a system for

enabling/locking the Transmission Control Module (TCM) (J217). 

‹› To perform adaptation of the anti-theft immobilizer.

Procedure

Check the identification of the previous Transmission Control Module (TCM) (J217) as follows:

-

Connect the scan tool.

-

Switch the ignition on.

-

Select "Diagnostic mode 9: Vehicle information."

-

Select the"Test-ID 04: Calibration identification". 

-

The Transmission Control Module (TCM) (J217) identification will be displayed, e.g.: 09G27750 L 0301

-

End of diagnosis and switch the ignition off.

Removal

-

Remove the left wheel housing liner

-

Disconnect the Transmission Control Module (TCM) (J217) electrical harness connector - A -.

-

 If equipped, disconnect the right side - 2 - and the left side - 5 - turn signal electrical harness from the Transmission Control Module (TCM)
(J217).

-

Remove the Transmission Control Module (TCM) (J217) bracket screws - 3 -.

-

Remove the Transmission Control Module (TCM) (J217) with the bracket attached.

Transmission Control Module Can-Bus Terminal Resistance, Checking|Page 8533 > < Transmission Control Module Can-Bus Terminal Resistance, Checking|Page 8531