Jetta Sedan L5-2.5L (CBTA) (2009)
Rear Door Window Motor: Service and Repair
Window Regulator Motor
Rear Door Windows, Sedan
Window Regulator Motor
‹› Removing and installing is described only for the right window regulator motor. Removing and installing the left window regulator motor is
derived accordingly from this.
Removing
-
Removing door trim..
-
Secure window using adhesive tape so that it does not slip down.
-
Remove the three bolts - 2 -.
-
Disconnect connector - 1 -.
-
Remove window regulator motor with control module - 3 - from mounting plate.
Installing
-
Attach window regulator motor - 3 - and connect harness connector - 1 -.
-
Pull door window lightly up and down so that splines are located better between motor and cable drum.
-
Tighten bolts - 2 - for window regulator motor.