Jetta Sedan L5-2.5L (CBTA) (2009)
-
Connect the brake pad wear indicator electrical connector.
-
Install the wheels..
‹› After replacing the brake pads and before moving the vehicle, always press the brake pedal firmly several times to properly seat the brake pads in
their normal operating position.
‹› Check the brake fluid level after replacing the brake pads.
Tightening Specifications
FN 3 Caliper
Brake Pads
Special tools, testers and auxiliary items required
‹› Torque wrench 5-50 Nm (VAG 1331)
‹› Piston resetting tool (T10145)
Removing
When removing, mark the brake pads if they will be used again. Install them in the same position, otherwise braking effect will be uneven!
-
Remove the wheels.
-
Using a screwdriver, pry off the brake pad retaining spring from the brake caliper - arrow - and remove.
-
Disconnect the electrical connector - 1 - for brake pad wear indicator.