Jetta Sedan L5-2.5L (CBTA) (2009)
/Page-348003.png)
The (T03004) must stand out approximately 3 mm on the inner side - B -. The surface - A - is the outer side. The surface - B - is the inner side
(sealing surface).
-
Cut the tube nozzle at the front marking (diameter of nozzle approximately 2 mm).
‹› The sealing flange for the crankshaft -belt pulley side- must be installed within 5 minutes after application of sealant.
-
Apply a sealant bead - A - as depicted into the groove of the sealing flange.
‹› Width of sealant bead: 2.5 to 3.0 mm
