Jetta Sedan L5-2.5L (CBTA) (2009)
-
Then, tighten the bolts in the cylinder block and in the upper section of the oil pan to 25 Nm.
-
Wipe off any excess sealant, which has leaked out.
-
Drive the alignment sleeves in until seated if necessary.
-
Install a new seal. Refer to --> [ Crankshaft Seal, Transmission Side ] See: Seals and Gaskets/Crankshaft Main Bearing Seal/Service and
Repair/Crankshaft Seal, Transmission Side.
The rest of the installation follows the reverse of the removal procedures. When doing this note the following:
‹› Install the brake booster vacuum pump. Refer to --> [ Brake Booster Vacuum Pump ] See: Brakes and Traction Control/Power Brake
Assist/Vacuum Pump/Service and Repair/Brake Booster Vacuum Pump.
‹› Install the cylinder head. Refer to --> [ Cylinder Head ] See: Cylinder Head Assembly/Service and Repair/Cylinder Head.
‹› Install the drive plate. Refer to --> [ Drive Plate ] See: Transmission and Drivetrain/Flex Plate/Service and Repair/Drive Plate.
‹› Remove the (T40069) from the cylinder block and install the locking bolt.
‹› Fill the cooling system. Refer to --> [ Draining and Filling ] See: Cooling System/Service and Repair/Cooling System, Draining and Filling.
Tightening Specifications