Jetta Sedan L5-2.5L (CBTA) (2009)
-
Rotate the tensioner - 2 - using a 15 mm open end wrench - A - in - direction of arrow - and secure using the (T10060A).
-
Remove the generator and coolant pump ribbed belt.
Installing
Installation is performed in the reverse order of removal, noting the following:
-
Place the generator and coolant pump ribbed belt onto the belt pulleys, then lastly onto the idler pulley - 3 -.
-
Before tensioning the generator and coolant pump ribbed belt, rotate the compressor belt pulley and check the ribbed belt for correct seating in the
belt pulley.
-
Before installing the A/C compressor ribbed belt, secure the tensioner using the (T10060A).
‹› When installing the ribbed belt, note direction of rotation of belt and be sure that it is seated correctly on pulley.
-
Start the engine and check belt running.
Ribbed Belt Pulley with Freewheel, Bosch
Ribbed Belt Pulley with Freewheel, Bosch
Special tools, testers and auxiliary items required
‹› Multi-point adapter (VAS 3400)
‹› Torque Wrench (V.A.G 1332) (or corresponding 40 - 200 Nm)
Removing
-
Remove the generator.
-
Clamp the generator at the mounting points in a vise.
-
Remove protective cap from ribbed belt pulley with freewheel.