Jetta Sedan L5-2.5L (CBTA) (2009)
Checking internal resistance
-
Using a multimeter, check the Knock Sensor terminals 1 to 2 for an internal short.
Specified value: infinite (Infinity).
If the specified value was not obtained:
-
Replace the faulty Knock Sensor (KS) 1 (G61)/Knock Sensor (KS) 2 (G66)
If the specified value was obtained:
Checking wiring
If the manufacturers test box is being used, perform the following step.
-
Install the test box.
If the manufacturers test box is not being used, perform the following step.
-
Remove the Motronic Engine Control Module (ECM) (J623). Refer to --> [ Motronic Engine Control Module, Replacing ] See: Computers and
Control Systems/Engine Control Module/Service and Repair/Motronic Engine Control Module, Replacing.
-
Using a multimeter, Check the Knock Sensor electrical harness connector to the Motronic Engine Control Module (ECM) (J623) electrical harness
connector T60 for an open circuit.