Jetta Sedan L5-2.5L (CBTA) (2009)
Wheel Hub with Wheel Bearing
Wheel Hub with Wheel Bearing
Special tools, testers and auxiliary items required
‹› Torque wrench 40-200 Nm (VAG 1332)
Removing
-
Loosen the drive axle to wheel hub bolt, refer to one of the following:
‹› If equipped with a hex bolt, refer to --> [ Drive Axle Hex Bolt, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and Repair/Drive
Axle Hex Bolt, Loosening and Tightening.
‹› If equipped with a 12 point bolt, refer to --> [ Drive Axle 12 Point Bolt, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and
Repair/Drive Axle 12 Point Bolt, Loosening and Tightening.
‹› When doing this, the vehicle must not rest on its wheels, otherwise wheel bearing may be damaged.
-
Remove the wheel.
-
Remove the brake caliper and secure to the vehicle using wire.
-
Remove the wheel speed sensor.
-
Remove the brake disc.
-
Press the drive axle out of the wheel hub (in direction of transmission) as far as possible.
-
Remove the wheel hub with wheel bearing bolts - arrows -.
-
Remove the wheel hub with wheel bearing from the wheel bearing housing.
Installing
Installation is performed in the reverse order of removal.
-
Install the brake caliper.
-
Tighten the drive axle to wheel hub bolt, refer to one of the following:
‹› If equipped with a hex bolt, refer to --> [ Drive Axle Hex Bolt, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and Repair/Drive
Axle Hex Bolt, Loosening and Tightening.
‹› If equipped with a 12 point bolt, refer to --> [ Drive Axle 12 Point Bolt, Loosening and Tightening ] See: Wheel Hub/Axle Nut/Service and