Jetta Sedan L5-2.5L (CBTA) (2009)
-
Remove the brake carrier with brake caliper and secure to the vehicle using wire.
‹› Secure the brake caliper to the vehicle.
-
Remove the bolt for the brake disc and remove the brake disc.
-
Remove the drive axle bolt using (T10162).
-
Remove the wheel hub and bearing from the drive axle.
Installing
-
Carefully slide the wheel hub and bearing onto the drive axle.
Make sure that wheel hub and bearing do not tilt!
-
Install a new drive axle bolt and tighten.
‹› First, tighten the bolt to specifications using a torque wrench.
‹› Use a wrench to apply the additional torque angle.
-
Install the dust cap using (3241/4).
‹› Always replace the dust cap.
‹› Damaged dust caps allow moisture to enter. Therefore, always use the tool shown.
Further installation is performed in reverse order.