Jetta Sedan L5-2.5L (CBTA) (2009)
Flex Plate: Service and Repair
Drive Plate
Drive Plate
Special tools, testers and auxiliary items required
‹› Depth gauge
Removing
-
Remove the transmission.
-
Lock the crankshaft, refer to --> [ Crankshaft, Locking ] See: Engine, Cooling and Exhaust/Engine/Cylinder Block Assembly/Crankshaft/Service
and Repair/Procedures/Crankshaft, Locking, and remove the drive plate.
Installing
-
Install drive plate only by using a washer with recesses - 1 - (without compensating shim - 2 -).
-
Install the new bolts - 3 - and tighten to 30 Nm.
-
Check dimension - a - an three points and calculate the mean value.
Specified value: 18.8 to 20.4 mm
‹› Measure through the drive plate hole to the surface of the control housing cover.