Jetta Sedan L5-2.5L (CBTA) (2009)
Seals and Gaskets: Service and Repair
Left Flange Shaft Seal, Replacing
Left Flange Shaft Seal, Replacing
Special tools, testers and auxiliary items required
‹› Slide hammer (VW 771)
‹› Pulling hook (VW 771/37)
‹› Thrust piece (T10160)
‹› Drip tray (V.A.G 1306)
‹› Torque Wrench (V.A.G 1331)
Removing
-
Remove left wheel.
-
Remove noise insulation
-
Remove lower part of left front wheel housing liner
-
Turn steering fully onto left lock.
-
Remove drive axle from flange shaft
-
Tie up drive axle as high as possible. Do not damage paint on drive shaft when doing so.
-
Place appropriate receptacle underneath transmission.
-
Remove bolts for flange shaft, by installing two bolts into flange and counter-holding flange shaft using a pry bar.
-
Pull out flange shaft with spring.
-
Pull out sealing ring for flange shaft using slide hammer-complete set (VW 771) and additional part for VW771 (VW 771/37).