Jetta SportWagen L4-2.0L DSL Turbo (CBEA) (2009)
Timing Belt: Service and Repair
Toothed Belt, Removing, Installing and Tensioning
Toothed Belt, Removing, Installing and Tensioning
Special tools, testers and auxiliary items required
‹› Securing pin (3359)
‹› Crankshaft stop (T10050)
‹› Counter-holder tool (T10172)
‹› Special wrench, long reach (T10264)
‹› Locking tool (T10265)
‹› Torque Wrench (V.A.G 1331)
‹› Torque Wrench (V.A.G 1332)
‹› Refer to --> [ Toothed Belt Drive Assembly Overview ] See: Toothed Belt Drive Assembly Overview.
Removing
‹› Ignition switched off.
‹› Engine must be cold.
‹› Adjustments to toothed belt may generally only be performed when the engine is cold, because the indicator position of the tensioning element
changes depending on engine temperature.
‹› The engine bracket must be removed to removing and install the tensioning roller. Refer to --> [ Engine Bracket ] See: Drive Belts, Mounts,
Brackets and Accessories/Engine Accessory Bracket/Service and Repair.
Procedure
-
Remove engine cover. Refer to --> [ Engine Cover ] See: Cylinder Head Assembly/Service and Repair/Engine Cover.
-
Remove fuel filter. Refer to --> [ Fuel Filter ] See: Tune-up and Engine Performance Checks/Fuel Filter/Service and Repair/Fuel Filter.
-
Remove auxiliary fuel pump. Refer to --> [ Auxiliary Fuel Pump ] See: Powertrain Management/Fuel Delivery and Air Induction/Fuel
Pump/Service and Repair/Auxiliary Fuel Pump.
-
Remove connector - 1 - from engine coolant temperature sensor on radiator (G83), open clips - arrows - and remove upper section of the toothed
belt guard.