Jetta SportWagen L4-2.0L DSL Turbo (CBEA) (2009)
-
Slide the protective housing on to the retaining plate.
-
Tighten shear bolts - 1 - uniformly until bolt heads shear off.
-
Install plenum chamber bulkhead.
-
Install the wiper arms and the plenum chamber cover.
-
If the ECM was replaced, connect the vehicle diagnostic tester and perform the "Guided Function, Replacing Engine Control Module".
-
Read the ECM DTC memory and erase all DTC entries.
-
Perform a test drive.
‹› Observe safety precautions that apply to road tests. Refer to --> [ Safety Precautions ] See: Fuel Delivery and Air Induction/Service
Precautions/Vehicle Damage Warnings/Safety Precautions.
-
Again, check the ECM DTC memory.