Jetta SportWagen L5-2.5L (CBUA) (2009)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor
Rear Wheel Speed Sensor
Removing
-
Raise the vehicle.
-
Disconnect the electrical connector - 1 - from the wheel speed sensor.
-
Remove bolt - 2 - from the wheel bearing housing.
-
Remove the wheel speed sensor from the wheel bearing housing.
Installing
-
Before installing the wheel speed sensor, clean the inner surface of the bore and coat the sensor completely with hot bolt paste (G 052 112 A3).
-
Install the speed sensor to the wheel bearing housing and tighten the bolt to 8 Nm.
-
Connect the electrical connector to the wheel speed sensor.