Jetta SportWagen L5-2.5L (CBUA) (2009)
Headlamp Washer Pump: Service and Repair
Windshield and Rear Window Washer Pump
Windshield and Rear Window Washer Pump
CAUTION!
‹› Turn off the ignition and all electrical consumers.
‹› Remove ignition key.
Removing
-
Remove front bumper cover.
‹› To avoid interchanging the washer fluid line connections on the Windshield and Rear Window Washer Pump (V59), the connections on the pump
and hose lines are color-coded. Hose connector pieces must be connected to the corresponding colored pump connections during installation.
-
To release, twist the securing clips at the hose connections - 3 - and - 5 - and disconnect them from the Windshield and Rear Window Washer
Pump (V59) - 4 -.
-
Collect the draining fluid in a suitable container.
-
Remove Windshield and Rear Window Washer Pump (V59) - 4 - upward out of reservoir.
-
Disconnect electrical connection - 2 -.
Installing
Install in reverse order of removal, noting the following:
-
Tighten all fasteners according to value in table. Refer to --> [ Windshield Washer System Tightening Specifications ] See: Specifications.
-
Bleed headlamp washer system after completing assembly work. Refer to --> [ Headlamp Washer System, Bleeding ] See: Service and
Repair/Procedures.