Jetta Wagon L4-1.8L Turbo (AWP) (2005)
/Page-1535002.png)
-
Activate secondary air injection pump relay via Output Diagnostic Test Mode (DTM).
Secondary air injection pump motor must run at intervals, and air must exit outlet connections.
If the motor runs, but no air exits:
-
Proceed with Output Diagnostic Test Mode (DTM) until completed.
-
Press keys 0 and 6 for function "End output" and confirm entry with Q key.
-
Switch ignition off.
-
Replace Secondary Air Injection (AIR) pump motor -V101-.
-
Check DTC memory.
-
Read readiness code.
-
Generate readiness code again if DTC memory has been erased or engine control module separated from permanent positive.
If the secondary air injection pump motor does not run at intervals:
-
Check activation of secondary air injection pump motor.
