Jetta Wagon L4-1.8L Turbo (AWP) (2005)
/Page-1874001.png)
Shifter A/T: Service and Repair
Selector Mechanism, Checking
Selector mechanism, checking, 09A, 5 Spd. A/T
Note:
^
It should not be possible to operate the starter while the selector lever is in position 2, 3, 4, D or R.
^
When traveling at speeds above 5 km/h and shifting into selector lever position N, the shift lock solenoid must not engage and block the selector
lever. The selector lever can be shifted into a driving gear.
^
When traveling at speeds below 5 km/h (almost stopped) and shifting into selector lever position N, the shift lock solenoid must not engage until
after approximately 1 second The selector lever cannot be shifted out of N position until the brake pedal is depressed.
Selector lever in "P" position and ignition switched on:
^
Brake pedal not depressed:
Selector lever is locked and cannot be shifted out of P position. Shift lock solenoid blocks selector lever.
^
Brake pedal depressed:
Shift lock solenoid releases selector lever. It is possible to shift into a driving gear. Shift selector lever slowly from P position through R, N, D, 4,
3 and 2 and check whether the display in the instrument cluster shows the correct selector lever position in each case.
Selector lever in N position and ignition switched on:
^
Brake pedal not depressed:
Selector lever is locked and cannot be shifted out of N position. Shift lock solenoid blocks selector lever.
^
Brake pedal depressed:
Shift lock solenoid releases selector lever. It is possible to shift into a driving gear.
Selector lever in D position, ignition and lights switched on:
^
Shift selector lever into Tiptronic gate.
The illumination of the D symbol in the selector lever display should go out, and the "+" and "-" symbols should light up.
The selector lever position display in the instrument cluster must change from "PRND432" to "54321" when the selector lever is moved into the
Tiptronic gate.
-
Check selector lever cable and adjust if necessary.
-
Check ignition key withdrawal lock.
