Jetta Wagon L4-1.9L DSL Turbo (ALH) (2003)
-
Disconnect wheel speed sensor and speed sensor wiring connector -1
-
Remove bolt -2- from stub axle.
-
Pull ABS wheel speed sensor out of stub axle.
Installing
-
Before inserting wheel speed sensor, clean mounting hole inner surface and coat speed sensor with lubricant G 000 650.
-
Insert wheel speed sensor into hole in stub axle and tighten bolt to 8 Nm (70 inch lbs.).
-
Connect wheel speed sensor to speed sensor wiring.
Wheel speed sensor on rear axle (drum brakes), removing and installing
Removing
-
Raise vehicle.
-
Disconnect wheel speed sensor and speed sensor wiring connector -1
-
Remove bolt -2- from stub axle.
-
Pull ABS wheel speed sensor out of stub axle.
Installing
-
Before inserting speed sensor, clean mounting hole inner surface and coat speed sensor with lubricant G 000 650.
-
Insert speed sensor into hole in stub axle and tighten bolt to 8 Nm (70 inch lbs.).
-
Connect speed sensor to speed sensor wiring.
ABS wheel speed sensor wiring to rear axle, removing and installing
Required special tools