Jetta Wagon L4-1.9L DSL Turbo (ALH) (2003)
Sealing Flange, Engine Rear: Service and Repair
Sealing flange and flywheel/drive plate, removing and installing
Note: For clutch repairs:
1. 120 Nm (89 ft. lbs.) + 1/4 turn (90°) additional
^
Always replace
^
Threads and shoulder must be free of oil and grease
^
To loosen and tighten, counterhold with 3415
^
Torque angle can be measured with Hazet 6690 torque angle meter, or equivalent
2. Crankshaft toothed belt sprocket
3. 15 Nm (11 ft. lbs.)
4. Oil seal
^
Replacing
5. Sealing flange, front
^
Must be located on dowel sleeves
^
Removing and installing
^
Replace using D 176 404 A2 silicone sealant
6. Engine block
^
Crankshaft, removing and installing
^
Pistons and connecting rods, disassembling and assembling
7. 60 Nm (44 ft. lbs.) + 1/4 turn (90°) additional
^
Always replace
^
Torque angle can be measured with Hazet 6690 torque angle meter, or equivalent
8. Flywheel/drive plate
^
Counterhold using 3067 to remove and install flywheel