Volkswagen Workshop Service and Repair Manuals > New Beetle > Body | General body repairs, exterior | Sliding roof | Sliding/tilting sunroof | Removing and installing sliding/tilting sunroof glass panel

Installing

Note

Panel must be installed in 0 position (panel closed).

Zero (0) position:

The mark -arrow- on the rear of the guide upper section -1- must lie within the marks dimension -a- on the guide plate -2- on both sides.

The guide plate -2- must be located in the guide rails (cannot be moved by hand).

If this is not the case, adjust parallel running → Chapter.

–	Place sunroof panel on from above and screw in securing screws (guide rail to panel).

–	Lightly tighten securing screws (Torx T25).

Note

After adjusting panel height, tighten securing screws (4.5 Nm).

Volkswagen Workshop Service and Repair Manuals