New Beetle L4-1.8L Turbo (AWP) (2003)
-
Clamp armrest in vise as shown.
Reinstall left and right bushings with tab (arrow) on bushing pointed towards and lined up with notch on front of armrest as follows:
-
Align tabs on bushings with front notch on armrest (arrow)
-
Place washer against bushing
-
Apply light pressure to washer using a bar clamp as shown.
Note:
Care must be taken when clamping bushings so as not to damage the foam isolating washers during The clamping process.
-
Depress armrest release and move armrest up and down while tightening bar clamp (this will allow bushings to slide into foam washers)